👑 Abaddon Crown・ STL File for 3D printing・Cults

STL 3d fashions and 3mf recordsdata (FILE ONLY) for a wearable Abbadon crown, based mostly on the main points seen in Haunted Resort.

IMPORTANT
Scaled for grownup ladies with a head circumference of approx. 22 inches. Earlier than printing, strive slicing only a few layers to verify the top gap will fit your needs and scale/form accordingly. I used to be capable of print with colours filament and solely wanted to masks/paint the gray center line.

Half 3mf recordsdata are already scaled and oriented in one of the best print high quality orientation. Components are scaled based mostly on a 250x250x250 mm construct quantity.

I made the horns hole and translucent to allow them to be lit up with fairy lights on the within. TIP, use a strip of clear packing tape sticky aspect up and stick the lights down flat after which use one other piece of clear tape to make a inflexible form that may be pushed up the horns, nice trick for a lot of completely different props. P.s. you might want skinny jewelers wire to get desired rigidity.

Comply with 3mf file settings for every half. Might have to extend gap tolerances for the horn/crown file as this was tight and required some sanding however your mileage my differ based mostly in your machines tolerances.

All items have been put along with simply press match and tremendous glue.

The jewel and jewel flame I printed with barely completely different golds so there’s a slight distinction. A dab of tremendous glue within the middle will maintain the flame in with no traces.

Scaled for grownup ladies with a head circumference of approx. 22 inches. Earlier than printing, strive slicing only a few layers to verify the top gap will fit your needs and scale/form accordingly. I used to be capable of print with colours filament and solely wanted to masks/paint the gray center line.